GE 45145 GE Choice Alert Wireless Panic Button User Manual

Page 6

Activating the Battery
The Panic Button is packaged with the battery

installed, but not activated. To activate the battery,

you must remove the yellow battery isolation strip.

Locate the yellow battery isolation strip on the side

edge; pull to remove. When removed, the Panic Button

will be active.

Assigning a Panic Button to a Device Location
The Control Center is designed to store up to four

Remote transmitters, such the Panic Button. In order

to ensure that the Panic Button will operate only with

your Control Center, it must be assigned to one of the

four device locations in the Control Center.
1. Press and hold the Learn button on the Control

Center. You will hear a short beep, followed shortly by a

long continuous beep. Release the

Learn button.

2. On the Control Center, press and release one of the

device numbers (1,2,3 or 4) that you want to assign

the Panic Button. The LED for that device number will

begin to flash.

1 2 3 4

Arm

Zone

Armed Power

Alert

Chime

Off

Mute

Learn

Input DC 12V

Step 1
Press and hold
the Learn button
for three seconds

Step 3
Activate the Panic Button.

Step 2
Press and release
the Device number