GE 45145 GE Choice Alert Wireless Panic Button - Manual (Page 10)

10 11
To Replace a Panic Button
If the Panic Button is lost or broken, you can either
replace it with another Panic Button or remove it
completely from the Control Center. To replace a
Panic Button (with another Panic Button or any of the
Remote transmitters) simply assign the new Panic
Button to the specific device number. The new Panic
Button will automatically replace the previous
Panic Button.
To Erase a Panic Button From a Control Center
CAUTION: Erasing a Panic Button from the Control
Center will also erase any sensors in the associated
zone. Sensors will have to be added back to the zone
(Refer to sensor manual or Control Center manual for
specific instructions).
To erase a Panic Button (or any Remote transmitter)
from device number location in the Control Center,
press and hold the ‘Learn’ button and the device
number at the same time on the Control Center
until the Control Center sounds two beeps. Release
both buttons.
*NOTE: Some early production Control Center
products were designed to allow replacement only.
In this situation you will only be able to replace the
remote transmitter with another. Contact Tech Support
at 800-654-8483 option 4 to determine if your Control
Center is an early production model.