GE ZV48SSFSS - Manual (Page 13)

49-80151-8
13
Installation Instructions
67(3%$OWHUQDWH0RXQWLQJ0HWKRG
“A” Centerline to Stud
and Keyhole Slots
“B” Hood Width At
the Top
ZV48T 19-9/16" 40"
ZV48S 23-9/16" 47-15/16"
ZV36T 13-9/16" 28"
ZV36S 17-9/16" 35-15/16"
ZV30T 10-9/16" 22"
ZV30S 14-9/16" 29-15/16"
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING METHOD
When necessary, the hood may be installed so that it is
VXSSRUWHGE\WKHVRI¿W
‡7KHVRI¿WVKRXOGEHFRQVWUXFWHGZLWK[·V
• Determine the installation location on the wall.
• Continue the centerline forward on the bottom of the
FDELQHWRUVRI¿W
• The opening above the hood should allow for the 10"
round duct and clearance to slide the hood back against
the wall.
A
Requires 10-1/2" Min.
Opening For Ductwork
and Hood Installation
A
• The 2 x 4 studs must be located as shown in the chart,
Dim. A. to accept mounting screws.
,03257$176RI¿WIUDPLQJPXVWEHFDSDEOHRI
VXSSRUWLQJXSWROEV
• Drill 1/8" pilot holes into the studs at the locations shown
in the top view illustration.
Install Transition Onto Top of Hood
• Place the transition piece over the hood exhaust and
secure with 4 screws provided.
• Use duct tape to seal the connection. Check to be sure the
damper moves freely.
0RXQW+RRGRQWR6RI¿WRU&DELQHW
Note: If mounting to the underside of a cabinet with a
UHFHVVHGERWWRPLQVWDOOVKLPVWR¿OOWKHJDS
Duct
Transition
Top of
Hood
• Drive mounting screws into the studs until they protrude
1/4". The 1/4" gap will provide clearance to engage the
keyhole slots in the top of the hood.
• Lift hood to installation position. Locate house wiring and
route through the knockout (from the back or top of the
hood).
• Lift hood onto mounting screws. Slide back against the
rear wall.
• Tighten mounting screws.
IMPORTANT: For additional support and to
minimize vibration during operation, the hood must
be secured to the back wall. Use wall anchors to
fasten bottom back of hood to the wall.
1/4" Gap
Push Back
to Wall
Add Shims
If Bottom
Is Recessed
Back
Wall
Cabinet
or
Soffit
Engage Top
Keyhole Slots
2"
7-1/2"
A
C
B 2-9/16"
8"
8-1/8"
6"
Back of Hood
Top View
Front of Hood
IMPORTANT: Remove
shipping tape from
damper and check that
damper moves freely.