GE JVM7195EFES - Manual (Page 17)

Snip all 4 webs
on each knockout
panel and
remove the metal
knockouts for rear
airflow.
Locate the two “knockout” plates, on the rear oven
panel, near the top of the oven.
Using tin snips, carefully cut the web area from the
two holes side-by-side (that secure the knockouts to
the oven). Cut all four webs on both rear knockouts;
this will allow the ventilation fan airflow to exhaust
out the rear of the oven.
CAUTION:
Be sure to trim the sharp
HGJHVIURPWKHRSHQLQJVDIWHUUHPRYLQJWKH
NQRFNRXWSODWHV
AFTER: Fan Blade
2SHQLQJV)DFLQJ
%DFN
7 Place the blower unit back into the opening.
9
8 Roll the blower unit 90° so that fan blade openings
are facing out the back of the oven.
5
17
Blower Plate
Before Rolling After Rolling
Back of
Oven
End A
End B
Back of
Oven
Back of
Oven
WARNING:
5LVNRIHOHFWULFVKRFN
can cause injury or death. Do not pull or stretch
WKHEORZHUXQLWZLULQJPDNHVXUHWKHZLUHVDUH
not pinched..
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave.
Installation Instructions
2YHQ5HDU3DQHO
6
Attach the exhaust adaptor to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
Close the blower plate so it is closed over the top
tab of the exhaust adapter. Secure with the screw
removed earlier.
Push down securely until it is in the lower locking
tabs. Take care to assure the damper hinge
is installed so that it is at the top and that the
damper swings freely.
Slide
exhaust
adaptor into
guides on
oven rear.
Exhaust Adaptor
Exhaust Adaptor
Damper
(hinge side up)
Locking
Tabs Guides
Back of
Oven
Screw
Screw