HP Parallel Uninterruptible Power System User Manual
Hp 3 phase ups user guide

HP 3 Phase UPS
User Guide
Abstract
This document includes installation, configuration, and operation information for the HP 3 Phase UPS. This document is for the person who installs and
maintains power products. HP assumes you are qualified in the servicing of high-voltage equipment and trained in recognizing hazards in products
with hazardous energy levels.
Part Number: 435256-004
January 2013
Edition: 4
Table of contents
Document Outline
- HP 3 Phase UPS User Guide
- Abstract
- Notice
- Contents
- Component identification
- UPS installation
- Precautions
- Preparing to install the hardware
- Installing the mounting rails
- Installing the UPS
- Removing the UPS battery bracket
- Installing the batteries
- Replacing the UPS battery bracket
- Attaching the UPS front bezel
- Connecting the ground bonding cable
- Connecting the REPO port
- Connecting the UPS to utility power
- Switching on the UPS battery circuit breaker
- Connecting devices to the UPS
- Charging the UPS batteries
- Powering up the standalone UPS
- Installing in a parallel configuration
- Installing the input and output wiring
- Wiring the terminal block
- Connecting the ground bonding cable
- Connecting the REPO port
- Connecting the UPSs to the Bus Bar
- Switching on the UPS input circuit breaker
- Switching on the UPS battery circuit breaker
- Connecting devices to the UPS
- Charging the UPS batteries
- Powering up the parallel system
- Adding an HP 3 Phase UPS to a parallel configuration
- Disconnecting from utility power
- Installing the UPS
- Configuring the Parallel UPS Card
- Removing the UPS battery bracket
- Installing the batteries
- Replacing the UPS battery bracket
- Attaching the UPS front bezel
- Connecting the ground bonding cable
- Connecting the REPO port
- Connecting the UPSs to the Bus Bar
- Connecting the UPS to utility power
- Switching on the UPS input circuit breaker
- Switching on the UPS battery circuit breaker
- Connecting devices to the UPS
- Charging the UPS batteries
- Powering up the parallel system
- ERM installation
- UPS operations
- Mimic screen
- Modes of operation
- Configuring the UPS
- Setting the Battery Low alarm level
- Running automatic battery tests
- Testing the front panel display
- Silencing an audible alarm
- Verifying the REPO port connection
- Powering down the standalone UPS
- Powering down an individual paralleled UPS
- Powering down the parallel system
- Communication
- Power management
- Maintenance
- Troubleshooting
- LED and audible alarm troubleshooting
- Abnormal output voltage at startup
- Battery breaker
- Battery connection condition
- Battery low condition
- Battery test condition
- Bypass is unavailable
- Check Parallel Board condition
- Configuration error and UPS does not start
- Phase rotation verification
- Power is not available at the UPS output receptacle
- Protected equipment is not on
- Overload condition
- Overtemperature condition
- Redundancy loss due to overload
- Selective trip
- Site wiring condition
- UPS detects software incompatibility
- UPS does not power down
- UPS does not power up
- UPS does not provide the expected backup time
- UPS does not transfer to Auto-Bypass mode
- UPS is on battery
- UPS is on bypass
- Specifications
- Spares
- Support and other resources
- Regulatory information
- Electrostatic discharge
- Acronyms and abbreviations
- Documentation feedback
- Index