HP Deskjet 695c Printer - Manual (Page 9)

9
Installing from the CD
(recommended method of installation)
If the “New Hardware
Found” dialog box
appears at any time
during the installation,
click in the upper-right
corner of the box, or
click Cancel.
Windows 95, Windows 98, Windows NT 4.0
6
Insert the CD into your CD-ROM drive.
After a few seconds, the HP DeskJet opening screen appears.
7
If the opening screen does not appear, do the
following:
Depending upon
the operating system on
your computer, your boxes
might differ from the
Windows 95 boxes shown
throughout this document
and the user’s guide.
a. Click Start on the taskbar, and then click Run.
b. Type d:\setup and click OK.
If your CD-ROM drive is assigned to a letter other than “d:,
type that letter instead.
8
When the opening screen appears, click Install the
HP DeskJet 690C Series Software on your PC and
follow the instructions on the screen.
Windows NT 4.0 users:
You need to set the
HP DeskJet 690C Series
Printer as the default
printer. See page 13
for instructions.
If something goes wrong, see page 14.
9
When the installer instructs you to restart Windows,
the installation is complete. Remove the CD from
your CD-ROM drive and restart Windows.