240 vac only, Miracle steamer, Warning – Antunes, AJ MS-150/155 User Manual
Page 7: Installation
![background image](/manuals/39896/7/background.png)
MIRACLE STEAMER
7
P/N 1010699 Rev. M 12/06
Unpacking
1. Remove the unit and all packing materials from
the shipping carton.
2. The unit should come with the items listed below:
• Owner’s Manual
• Authorized Service Agency Directory
• Inlet Hose Assembly (MS-250/255 only)
• Spatula Assembly (MS-150/250 only)
• Drawer Assembly (MS-155/255/355 only)
NOTE: If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at
1-877-392-7854 or 1-630-784-1000.
3. Remove all packing materials and protective cov-
erings from the unit.
4. Remove and wash all removable parts in soap
and water. Rinse with clean hot water and allow
to air dry.
5. Wipe all surfaces of the unit with a hot, damp
cloth.
NOTE: Do not use a dripping wet cloth. Wring out
before use.
6.
MS-150/250 Models: Assemble the
INSTALLATION
Figure 1. Assembling Handle–MS-150/250 Only
Bolt
Handle
Spatula
Handle Guard
THIS UNIT IS DESIGNED TO
OPERATE ON 208 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING
WARNING
THIS UNIT IS DESIGNED TO
OPERATE ON 120 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING
WARNING
120 VAC
ONLY
208 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS UNIT IS DESIGNED TO
OPERATE ON 220-240 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING
WARNING
220-240
VAC ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
Guard and Mounting Bolt to the Spatula as shown in
Figure 1.
7. Install the Wire Trivet into side slots on Spatula.
8. Re-install all removed parts.
Wire Trivet