Antunes, AJ MS-150/155 - Manual (Page 17)

MIRACLE STEAMER
17 P/N 1010699 Rev. M 12/06
Figure 9. Water Tank Filter–MS-150/155 Only
Water Tank Filter
WATER TANK FILTER–MODELS MS-150/155 ONLY
The Water Tank Filter is used to prevent solids or food
products from entering and damaging the water pump.
The unit uses a water filter (Figure 9). Inspect and
clean this filter monthly or more regularly using the fol-
lowing procedure:
NOTE: The water level should be very low or near
empty.
1. Turn the unit OFF. Unplug the power cord and
allow the unit to cool down before proceeding.
2. Open the Slide Door (Figure 9).
3. Remove the filter, located inside the tank, by pull-
ing it upwards and out of the bottom hole.
4. Clean the Filter by running it under tap water.
Replace the Filter if the screen is torn or dam-
aged.
5. Reinstall the filter stem into the bottom hole of the
tank (Figure 9).
6. Fill the Water Tank and test the unit.
NOTE: The MS-355 does not use a water filter.
Figure 10. Inlet Hose Assembly
Male Quick
Disconnect Insert Strainer Cup
Tubing
CHECKING AND CLEANING THE WATER
STRAINER (MONTHLY MS-250/255 ONLY)
The Water Strainer protects your equipment from any
foreign debris in the water line that could get into the
food, damage the unit’s solenoid (causing the unit to
leak or flood) and protect from interference with the
equipment’s proper and consistent operation
To ensure proper and consistent steaming results,
visually check the water pressure regulator gauge and
strainer cup regularly. If the pressure on the gauge
has dropped, visually check the clear, plastic strainer
“cup” and clean out the accumulated debris as follows.
1. Shut off the water supply valve to the unit,
unscrew the clear, plastic strainer “cup” and care-
fully remove the mesh strainer screen.
2. At the sink, gently flush all of the accumulated
debris from the strainer cup and mesh strainer.
Be especially careful not to damage the mesh
strainer screen.
3 Carefully place the mesh strainer screen into its
seat at the bottom of the clear, plastic cup and
confirm that the orange O-ring is properly seated
in its place before screwing the strainer cup and
top back together.
4. Purge the air out of the strainer and tubing by
disconnecting the male quick disconnect insert
from the equipment and, over a bucket, push the
“white” plastic tip in until there is good water flow.
5. Replace damaged or warn parts as needed.
6. Verify that the Water Pressure Regulator is set to
20-25 PSI (1.4-1.7 kg/cm2 or 138-172 kPa).
MAINTENANCE (continued)
Filter Stem
Access
Cover
with Tank
(dotted line)
Bottom
Hole
of Water
Tank
Slide Door
Mesh
Screen
O-ring