Antunes, AJ MS-150/155 - Manual (Page 19)

MIRACLE STEAMER
19 P/N 1010699 Rev. M 12/06
TROUBLESHOOTING
WARNING
To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equip-
ment should be performed by qualified service personnel. The unit should be unplugged when servicing,
except when electrical tests are required.
Problem Possible Cause Corrective Action
Control Display is Blank (power On/
Off switch is On but indicator light is
off).
The power cord is not correctly
plugged in.
Plug the power cord into the appro-
priate outlet.
The power cord and/or electrical
plug is damaged.
Inspect electrical wire, plug, and
receptacle.
The main electrical panel circuit
breaker is off or has been tripped.
Reset circuit breaker. Contact your
maintenance person or Authorized
Service Agency if it trips again.
Switch is inoperable. Contact your maintenance person or
Authorized Service Agency for ser-
vice.
Control Display is blank (power On/
Off switch is on and indicator light is
on).
Control Board is inoperable Contact your maintenance person or
Authorized Service Agency for ser-
vice.
Transformer is inoperable.
Loose, burnt, or broken wires in cir-
cuit.
Unit does not heat up (Control
Display is on)
Hi-Limit Thermostat is tripped or
inoperable.
Reset the Hi-Limit Thermostat
according to the Operations sec-
tion of this manual. If the Hi-Limit
Thermostat requires continuous
resetting, contact your Authorized
Service Agency for service.
Solid State Relay is inoperable.
Thermocouple is inoperable.
Control Board is inoperable.
Steam Generator is inoperable.
Loose, burnt, or broken wires in cir-
cuit.
The unit’s main electrical panel cir-
cuit breaker trips.
Damaged receptacle, plug, or cord;
a loose connection or an internal
component failure.
Turn the unit off, allow it to cool to
room temperature, and then restart
the unit. Contact your maintenance
person or Authorized Service Agency
if the condition repeats.
Water leaking inside electrical hous-
ing.
Pinhole leak in rubber hoses (MS-
150/155/355).
Replace hoses.
Loose or damaged water line tubes
and/or fittings inside electrical hous-
ing.
Tighten or replace tubes and/or fit-
tings.
“ ERR” appears in the Control
Display.
Programming and/or SHO and
H2O values were adjusted/changed
improperly.
Reset the Control Board as
described in the Programing section
of this manual. See Fault Codes.