HP Mini 2102 - Manual (Page 74)

b. Grasp the edge of the memory module (2), and gently pull the module out of the memory
module slot.
To protect a memory module after removal, place it in an electrostatic-safe container.
6. Insert a new memory module:
CAUTION: To prevent damage to the memory module, hold the memory module by the edges
only. Do not touch the components on the memory module, and do not bend the memory
module.
a. Align the notch (1) in the memory module with the tab in the memory module slot.
b. With the memory module at a 45–degree angle from the surface of the memory module
compartment, press the module (2) into the memory module slot until it is seated.
c. Gently press the memory module (3) down, applying pressure to both the left and right
edges of the memory module, until the retention clips snap into place.
CAUTION: To prevent damage to the memory module, be sure that you do not bend the
memory module.
7. Follow the instructions in the section “Replacing the vanity cover,” earlier in this guide.
66 Chapter 11 Memory modules