HP DesignJet 500 - Manual (Page 166)

Media & Ink Introduction Front-Panel Other Index Solutions
The Front-Panel Setup Menus Consumable Menus Internal Prints Navigation
Message
Descriptions
Printer
Options
Printhead Status Messages
Status
Numbers
XX ranges 1
from 00 - 55
1.See Status Code Interpretation
Printhead Message
Description Procedure
XX02 Reseat
XX06 Reseat
XX08 Reseat
The Printhead may only be
badly seated. This means there
is a bad electrical connection
between the printhead and the
printer carriage. Try these steps below. If the message
returns to OK after performing the first
step, do not continue.
1. Remove the printhead and insert
the printhead again.
2. Remove the printhead and clean
the interconnect, refer to
Carriage
Interconnect Wiper .
3. Replace the printhead.
XX10 Reseat There is an electrical failure