HP DesignJet 500 - Manual (Page 156)

Media & Ink Introduction Front-Panel Other Index Solutions
The Front-Panel Setup Menus Consumable Menus Internal Prints Navigation
Message
Descriptions
Printer
Options
Full ink cartridges
needed The ink system startup must
have full cartridges to
enable the initialization of
the complete ink system. Remove the ink cartridges and
replace with ink cartridges that
are full of ink.
Have ink tube replaced
or risk printer damage
Contact HP The internal ink system
tubes need replacing
urgently. Contact your HP
representative to arrange for
an on-site visit to perform the
maintenance procedure.
HP is not responsible for
damage from use of non-
HP ink Select YES to
replace To ensure that you always
get excellent image quality
from you printer it is
important that you use
genuine Hewlett-Packard
components. Select ‘Yes’ and replace with
genuine HP components See
Ordering Accessories .
Initializing printer
Please wait. The printer needs some
time when you first turn the
printer on from the power
switch. You can put the printer into
Standby Mode this will return
to the ready status much
quicker. See
Standby
Ink drying, please wait The media has finished
printing but due to certain
conditions the image needs
time to dry. To adjust the settings to the
drying time see
Drying Time
Settings
Status Description Procedure