The printer is prompting you
to lift the window of the
printer so that you can
install ‘normal’ printheads
into the printer. you must
only remove the Setup
printheads when you have
initialized the printer first.

It is vital to the correct
functioning of your printer, that
the Setup procedure is
performed correctly. Use the
Setup Instructions which came
with your printer to guide you
through the steps.

Media loaded incorrectly.
Remove media.

The media is mis-positioned
or mis-aligned.

Before the printer can continue
you must remove the media.
See

Loading Roll Media

Media misaligned.
1_ Lift lever
2_ Align Media with
both edges of roll
3_ Lower lever

The printer is helping you
with the load roll media
procedure.

For an animation on the
loading roll procedure see

Loading Roll Media

Media misaligned.
1_ Lift lever
2_ Align right edge
with blue line
3_ Lower lever

The media is not being fed
into the printer straight.

For guidelines on loading
media see

Loading Roll Media

Guidelines

Status

Description

Procedure