HP DesignJet 500 User Manual
Page 159
Media mispositioned.
1_ Lift lever
2_ Correct position
3_ Lower lever
The roll is mis-positioned in
the printer. This may mean
the media is too far to the
left on the platen
For guidelines on loading
media see
Loading Roll Media
Guidelines
Media too small
The media you are
attempting to load is too
small for the printer to use.
For the minimum size of media
the printer can use see
Misalignment
This means that the media
has not been fed into the
printer straight.
Reload the media making sure
that the edges of the media
are parallel and that it is
straight when you feed it in.
Align the media coming out
from the printer with the media
going into the printer, see
Loading Roll Media
Misposition
The media is not positioned
correctly in the printer. The
media may be too far to the
left or the right.
Check you have loaded the
media correctly as shown in
the procedure
Loading Roll
Media
No media profile
available. Unload roll.
The media you are
attempting to load does not
have a media profile
associated with it, so the
printer does not know how
to print on it.
See
Media Profile
Downloading
for details of the
down loading media profiles
procedure. If this is not
successful, switch the printer
On and then Off again.
Status
Description
Procedure