HP ProLiant DL360p Gen8 Server - Manual (Page 52)

Hardware options installation 52
3. Install the drive.
4. Determine the status of the drive from the drive LED definitions (" Hot-plug drive LED definitions " on page
18 ).
DVD-ROM and DVD-RW drive option
All configurations of this server, except the 10 SFF drive configuration, support the installation of a DVD-ROM
drive or a DVD-RW drive.
To install the component:
1. Power down the server (on page 20 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 20 ).
4. Remove the access panel (on page 23 ).
WARNING: Eliminate the risk of electric shock by removing all AC power from the system before
installing or replacing any non-hot-plug hardware option. Disconnect all power cords to
completely remove power from the server.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.