HP ProLiant DL360p Gen8 Server - Manual (Page 23)

Operations 23
The display can be rotated up to 90 degrees.
Remove the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
To remove the component:
1. Power down the server (on page 20 ).
2. Extend the server from the rack (on page 20 ).
3. Open or unlock the locking latch, slide the access panel to the rear of the chassis, and remove the
access panel.
Install the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the
rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the hood latch. The access panel slides to a closed position.
3. Tighten the security screw on the hood latch.
Remove the FBWC capacitor pack
1. Power down the server (on page 20 ).
2. Remove all power:
a. Disconnect each power cord from the power source.