HP D2200sb Storage Blade - Manual (Page 15)

Setup 15
Installing a storage blade
CAUTION: To prevent improper cooling and thermal damage, do not operate the storage blade
or the enclosure unless the first drive bay is populated with a drive, and drive bays 2 and 3 and
all device bays are populated with either a component or a blank.
CAUTION: Thermal regulation is maintained only when the drive drawer is closed. The drive
temperature alarm is triggered under the following conditions:
• A slow beep and flash (1 every 5 seconds) indicate that the drive drawer is open. The drives
are not fully protected by system air flow.
• A fast beep and flash (2 per second)—To avoid drive damage or data loss and storage blade
shutdown, close the drive drawer immediately.
When the drives reach critical temperatures, the system shuts down.
1. Install the hard drives (" Installing a hard drive " on page 18 ).
2. Remove the enclosure connector cover.
3. Identify the partner server blade to be installed with the storage blade:
o To install the storage blade with a half-height server blade, proceed with the next step.