HP D2200sb Storage Blade - Manual (Page 10)

Operations 10
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the storage blade.
To power down the storage blade, power down the partner server blade. See the server blade
documentation.
Remove the storage blade
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the storage blade
before beginning any installation procedure. Improper grounding can cause ESD.
To remove the component:
1. Identify the proper storage blade.
2. Power down the partner server blade (on page 9 ).
3. If the partner server blade is a full-height server blade, do one of the following:
o Remove the blank installed above the storage blade.
o Remove the half-height device installed above the storage blade.
For information about removing a half-height device, see the half-height device user guide.
4. Remove the storage blade: