HP D2200sb Storage Blade - Manual (Page 12)

Operations 12
To remove the component:
1. Power down the partner server blade (on page 9 ).
2. Remove the storage blade (on page 10 ).
3. Press the access panel release button.
4. Slide the access panel toward the rear of the storage blade.
5. Remove the access panel.
Install the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
CAUTION: Do not operate the storage blade with the access panel open or removed. Operating
the storage blade in this manner results in improper airflow and improper cooling that can lead
to thermal damage.
To install the component:
1. Place the access panel on top of the storage blade. Allow the panel to extend past the rear of the
storage blade approximately 0.8 cm (0.2 in).
2. Slide the access panel toward the front of the storage blade. The access panel locks into position.