HP NC373F PCI-E Multifunction 1000SX Gigabit Server Adapter - Manual (Page 10)

Installing an adapter 10
1. Using a correctly sized slotted screwdriver, carefully remove the two board lock screws located at
the top and bottom of the connector.
2. Remove the standard profile bracket and place the low profile bracket over the connector. Be careful
not to damage the connector or bind the low profile bracket to the connector.
Connecting the network cable
The HP NC373F PCI Express Multifunction Gigabit Server Adapter uses an LC fiber port. This port
supports multimode fiber with a maximum cable length dependent on the fiber type, mode, and cable
size. See Specifications (on page
11 ) for the maximum cable length.
To insert the LC connector into the adapter port, line up the slot on the fiber connector with the adapter
and gently push until the retainers click into place.