HP LASERJET PRO P1102w - Manual (Page 42)

Network connection (wireless models only)
The product can connect to wireless networks.
Supported network protocols
To connect a networking-equipped product to a network, you need a network that uses one of the
following protocols.
● TCP/IP (IPv4 or IPv6)
● Port 9100
● LPR
● DHCP
● AutoIP
● SNMP
● Bonjour
● SLP
● WSD
● NBNS
Install the product on a wireless network with HP Smart Install
NOTE: This installation type is supported for Windows only.
The HP Smart Install allows you to install the product driver and software by connecting the product to a
computer through a USB cable. If the product previously has been installed on a network, reset the
wireless defaults. See Restore default wireless settings on page 31 .
NOTE: The installation CD is not required during a HP Smart Install. Do not insert the software
installation CD into the computer CD drive.
1. Turn on the product, and then connect the USB cable to the product and the computer. The
installation program should start automatically.
28 Chapter 4 Connect the product ENWW