HP Access Control - Manual (Page 12)

5 Generate new PUK code
This section describes how to generate a new PUK code.
5.1 Login
1. Open a web browser and enter the following in the address field:
http://servername/hpac
Where servername is the name or IP address of the server containing the installation of HP Access
Control Web Interface Configurator.
2. If prompted, enter credentials.
3. Click Login.
4. Click the Setup icon.
Figure 5-1 Home screen
5.2 Generate new PUK code
1. Click the Codes tab.
Figure 5-2 Codes tab
2. Note your current PUK code and ID codes.
3. Generate a new PUK code by clicking the Generate new PUK code button.
6 Chapter 5 Generate new PUK code