HP StorageWorks 500 G2 Modular Smart Array - Manual (Page 20)

This section describes the following topics:
• Installing Smart Array Multipath software
• Uninstalling Smart Array Multipath software
Following is the syntax of the command for executing silent installation:
:\MPInstall\setup.exe /s /f1“C:\setup.iss” /f2“C:\MPSIn-
stallLog.txt”
The refers to the drive which contains the installation media. The setup.iss is
the response file from which information is taken for silent installation. The MPSInstallLog.txt file
records information about the silent installation.
The ResponseResult section of the MPSInstallLog.txt log file displays the result code, indicating
whether or not the silent installation succeeded. An integer value is assigned to the ResultCode keyname
in the ResponseResult section.
lists the common return values along with their descriptions in the ResultCode key.
Table 9 List of common return values
Result Code Description
0 Success
–1 General error
–3 Required data not found in the setup.iss file
–4 Not enough memory available
–5 File does not exist
–6 Cannot write to the response file
–7 Unable to write to the log file
–8 Invalid path to the InstallShield Silent response ( .iss ) file
–51 Cannot create the specified folder
–52 Cannot access the specified file or folder
NOTE:
The C: in /f1C: and /f2C: refers to a local drive on the system, or a network drive that is used to obtain
the response file and write the MPSInstallLog.txt (provided there is write permission in the directory).
= C:\Program Files\Hewlett-Packard\HP MPIO DSM\SMART ARRAY DSM
= a directory on the system on which the new installation is to be done or the
directory of an existing installation.
You must enclose the paths to the response file and the log file, which records the information about the
silent installation, in quotes(”).
Installing Smart Array Multipath software
To perform silent installation, complete the following steps:
1. Create a copy of the new.iss file in the installation kit.
2. Rename this copy of the file as setup.iss.
3. Choose one of the following options:
• To install the Microsoft MPIO Framework component along with the DSM component, use the
renamed default setup.iss file.
20 Installation and operation in Microsoft environments