HP Cisco MDS 8Gb Fabric Switch for HP BladeSystem c-Class - Manual (Page 13)

Cisco MDS 8Gb Fabric Switch for HP BladeSystem c-Class User Guide 13
5. Push firmly into the interconnect bay (see Figure 5 ).
Figure 5 Installing the Cisco MDS 8Gb Fabric Switch into an interconnect bay
6. Press the installation handle into the latch to lock the switch in place.
OA power verification
As defined earlier, the HP BladeSystem Onboard Administrator is the enclosure management tool that
manages the devices contained within the enclosure. The OA provides a single point from which to
perform basic management tasks on switches or server blades installed in the enclosure.
IMPORTANT:
HP recommends reading the HP BladeSystem c7000 Enclosure User Guide and the HP BladeSystem
Onboard Administrator User Guide in sequence to gain an overall understanding of the enclosure system.
Once the switch is installed in a supported interconnect bay, the OA verifies that the switch type matches
the mezzanine cards present on the servers. If there is no mismatch, the OA powers up the switch. If the
switch does not power up, check the enclosure and switch status using the OA web interface. For more
information, see the HP BladeSystem Onboard Administrator User Guide.
EXT 5
EXT 8
EXT 7
EXT 8
Cisco MDS 9124e
4 EXT 5
199541