Cd/dvd tattoos – HP Deskjet 6988dt Printer User Manual
Page 83
Print
1.
Open the
dialog box.
2.
In the Paper Size drop-down list, click A4 Banner or US Letter Banner.
3.
Click OK.
4.
Open the
dialog box.
5.
Select the Paper Type/Quality pane, and then specify the following settings:
–
Source: Upper tray
–
Paper Type: Automatic or Plain paper
6.
Select any other print settings that you want, and then click Print.
CD/DVD tattoos
Guidelines
●
Refer to the instructions that are included with the media for the most current printing
tips.
●
To avoid damage to the printer, do not feed a sheet of tattoos through the printer
more than once.
●
Separating any part of the tattoo from the protective backing sheet before printing
could harm the printer. Be sure that the tattoo covers the entire backing sheet with
no exposed spaces.
●
Do not use tattoos that are separating from the backing sheet, or that are wrinkled,
curled, or damaged in any way.
●
If the tattoo sheets do not easily feed through the printer, try one of the following
suggestions:
–
Do not load the In tray to capacity.
–
Fan the stack of tattoos.
–
Feed the tattoos one sheet at a time.
Prepare to print
1.
Verify that the printer is turned on.
2.
Remove the Out tray, and then remove all paper from the In tray.
3.
Slide the paper-width guide all the way to the left, and then pull out the paper-length
guide.
4.
Insert one sheet, pushing it all the way into the printer until it stops.
5.
Slide the paper guides firmly against the sheet.
6.
Replace the Out tray.
Note
Before printing a tattoo, print a practice page to test the layout of the
design. The design might need to be adjusted slightly.
1.
dialog box and set the paper size, scaling, or
orientation options.
2.
Open the
dialog box.
User's guide
81