Check the quantity of ink on the substrate, Substrate settings – HP Latex 210 Printer User Manual
Page 71
Passes
Uni/
bidir
Self
adhesi
ve
Banner
Textile
Film
Synthet
ic
paper
Paper
aqueou
s
Paper
solvent
Low
temp.
Mesh
18*
Bidir
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
20 to 32
Bidir
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
* Unlike other printmodes, the 18-pass printmode has 1200 dpi x 1200 dpi input data resolution at 1
bpp (1 bit per pixel). Therefore, to generate a 18-pass media preset you should start either from an
existing 18-pass preset or from scratch. In the same way, do not clone an 18-pass media preset to
generate a preset with a print mode other than 18-pass.
Key
●
Bidir: bidirectional
●
No: not recommended
●
Maybe: may be worth trying for extra speed
●
Start here, Yes: recommended
NOTE:
More specific settings for many substrates from different vendors are available in the HP
Media Finder
.
Check the quantity of ink on the substrate
Check that the ink quantities in your media preset are adequate. Look at the color patches in the HP
diagnostic chart and check that the patches have the correct amount of ink using the guidelines below:
1.
Too much ink: There are several possible symptoms of this problem.
●
The last two or three scales of the chart look the same.
ENWW
Add a new substrate
67
Substrate settings