HP Integrity NonStop J-Series - Manual (Page 87)

Figure 34 SET SESSION example 2
Using the Control Query Defaults tab
To add or modify a CQD configured for a data source:
1.
Under the navigation tree pane, click Connectivity.
2. Complete the initial steps to create a data source until you see the following shown in
Figure 35 (page 87) .
Figure 35 Data source configuration
For information on creating a data source, see “Creating a data source” (page 82) or
“Updating a data source” (page 91) )
3. Click Control Query Defaults.
4. Click Add... or Modify...
5. In the CQD Name field, enter a new name or change the existing name.
6. In the Value field, enter a new CQD value, or change the current value.
Figure 36 Add CQD
Using the Control Table Statements tab
The Control Table Statements tab allows you to modify certain options for specific tables.
Creating a data source 87