HP 3PAR VSS Provider Software - Manual (Page 28)

Table 3 Application Events (continued)
Action Description Event
ID
None. Exec: 5041
Internal logging, which records the task from the HP 3PAR VSS
Provider for Microsoft Windows to the HP 3PAR Storage System.
None. Virtual Copy exported. 5042
A point-in-time snapshot disk is created and exported to the host.
None. Virtual Copy removed. 5043
The exported snapshot disk is removed from the host.
The request is not supported by the
current release. Contact your local
service provider for a future release. Unsupported feature .
The HP 3PAR VSS Provider for Microsoft Windows received an
unsupported request through the VSS framework.
5050
Reduce the number of snapshot requests
in one snapshot set to less than 64, and
request again. A snapshot in one set has exceeded the maximum limitation.
HP 3PAR VSS Provider for Microsoft Windows supports up to 64
snapshots in one set. This request has exceeded the maximum
limitation.
5051
Insufficient memory is available to allow
HP 3PAR VSS Provider for Microsoft Could not allocate memory.
Internal error, failed to allocate memory during computing.
5052
Windows to operate normally. Shutdown
some of the idle applications that are still
running and resume the previously failed
task.
See “System Setup” (page 10) , to check
for CLI installation.
Could not communicate with HP 3PAR CLI.
The initial check on the HP 3PAR CLI configuration has generated
an error. This could be due to following reasons:
5053
•
the HP 3PAR CLI is not installed.
• A valid password file could not be found or its contents are not
valid for this installation.
Correct the error and try again, or
contact your local service provider if the
error continues.
This is an error message that usually is associated with Event ID
5041. This event describes the cause to the action on Event ID
5041.
5054
Set the LogLevel to ‘4’ to show the detail
error message to log file, and retry. : Invalid token.
Internal error. The output format does not match.
5055
Set the LogLevel to ‘4’ and look for
vvmap as from the
3parprov.log
.
Could not open the volume mapping file: . Failed
to open the mapping file that is generated by the showvv –d CLI
command. 5056
Look for file to see if the
permissions are set correctly. Could not open file:
The HP 3PAR VSS Provider for Microsoft Windows failed to open
the temporary file that is generated internally.
5057
Contact your local service provider with
the detailed log file. Could not create file .
The HP 3PAR VSS Provider for Microsoft Windows failed to open
the temporary file which is generated internally.
5058
Try to correct the system error based on
the message. Generic system error.
This error message is generated by the system.
5059
28 Diagnostics