HP 3PAR VSS Provider Software - Manual (Page 19)

-syncrc Yes|No
Optional. Enables (Yes) or disables (No) synchronous Remote Copy.
•
The following option can be used with the Log subcommand:
-level
Changes log level details output to the log file. The valid range is from 1 to 5. The default value
is 5.
USAGE:
•
To view the current system communication setup, issue ProvCfg StoreServ.
•
To view all system communication setups, issue ProvCfg StoreServ [-detail].
•
To view a specific system communication setup, issue ProCfg StoreServ [-sys ]
[-detail]
.
•
To add or modify the system communication setup, issue ProvCfg StoreServ [-sys
] [-user ] [-pass ] [-sockssl on|off
].
•
To enable or disable the use of SSL, issue ProvCfg StoreServ [-sys ]
[-sockssl on|off]
.
•
To set as default entry, issue ProvCfg StoreServ [-sys ] [-default].
•
To remove an existing system setup, issue ProvCfg StoreServ [-sys
[-remove]
.
•
To view the current connection configuration, issue ProvCfg Conn.
•
To enable or disable the no block option when creating virtual copies, issue ProvCfg Conn
-noblock Yes|No
.
•
To view the current log level, issue ProvCfg Log.
•
To change the current log level, issue ProvCfg Log -level .
EXAMPLES:
•
The following command adds a new entry for the system configuration.
ProvCfg StoreServ -sys MyStorageSystem -user myuser -pass mypassword
•
The following command changes the log level to 4.
ProvCfg Log -level 4
•
The following command changes the timeout value to 120 seconds.
ProvCfg Conn –timeout 120
•
While registering new StoreServ Storage System with HP 3PAR VSS Provider, if the certificate
is not saved earlier or the certificate is invalid or expired, ProvCfg command output might
be different. The image shows the ProvCfg command output when the certificate is not saved
earlier.
Using the ProvCfg Command to Set Up or Modify a System Connection 19