HP 3PAR Application Software Suite for Oracle - Manual (Page 42)

3.4 Installing Recovery Manager on Linux Systems
Recovery Manager for Oracle User’s Guide
3.3 Installing Recovery Manager on Linux Systems
Use the instructions in this section to install 3PAR Recovery Manager software on both the
primary and backup hosts.
3.3.1 Starting Installation
The following section describes the steps necessary for installing 3PAR Recovery Manager on a
Linux system:
To install 3PAR Recovery Manager:
1 Log in as the root user.
2 Insert the 3PAR Recovery Manager CD into a CD-ROM drive.
3 Change to the CD-ROM drive.
4 Issue the rpm command as follows:
CAUTION: When upgrading to a newer version of 3PAR Recovery Manager, any
previously installed versions of Recovery Manager must be removed. Use the rpm
-e VCDBAora command to remove the previously installed package.
NOTE: If the CD is not mounted automatically, you can mount it manually.
# mount -t iso9660 -r /dev/cdrom /mnt/cdrom
# cd /mnt/cdrom0
# rpm –ihv –-percent -–nodeps VCDBAora-302-1.i386.rpm