HP 3PAR Application Software Suite for Oracle User Manual

Page 172

9.4

System Configuration

Recovery Manager for Oracle User’s Guide

■

Either one or two Remote Copy group(s) must be created, which contain all virtual volumes

used by datafiles and archive log destinations. The one group option requires that datafiles

and archive log destinations are in the same group. The two group option rqeuires that the

archive log destination(s) is in a different group from datafiles.

■

Recovery Manager only supports the

mirror_config

policy (default) for the involved

Remote Copy target.

■

Recovery Manager only supports periodic synchronization and requires the period value set

to zero for the involved Remote Copy group.

■

If volume manager is being used, all volumes that are in the same disk group as the

datafiles or archive log destinations must be admitted to the Remote Copy group.

■

If ASM is being used, all volumes that are in the same ASM disk group as the datafiles or

archive log destinations must be admitted to the Remote Copy group.

■

Remote copy group must be started and in synchronized status.

■

Refer to the 3PAR Remote Copy User’s Guide to set Remote Copy targets, links, and groups.

After the above has been set up, a Recovery Manager configuration file must be created. There

are three ways to create a configuration file.

On the backup host:

Run

/opt/3par/vcdbaora/bin/vcdbagui

to start the Recovery Manager Graphical

User Interface (GUI).

Run

/opt/3par/vcdbaora/bin/vcdba_main

to start the Recovery Manager menu-

driven utility.

Run

/opt/3par/vcdbaora/bin/vcdba_config

to start the Command Line Interface

(CLI).

Refer to the

on page 4.27 to setup the configuration

file for Remote Copy.

This manual is related to the following products: