HP ProLiant ML310 G5p Server - Manual (Page 41)

Hardware options installation 41
6. Install the PCI fan.
7. Install the system air baffle and PCI card guide.
8. Connect the PCI fan cable to the PCI fan connector on the system board (" System board components "
on page 11 ).
9. Install the PCI-X expansion board in slot 1, as needed (" Installing expansion boards " on page 39 ).
10. Install the access panel (on page 18 ).
11. Lock the bezel.
12. Power up the server (on page 16 ).
SAS controller
To install the component:
1. Power down the server (on page 16 ).
2. Unlock the bezel (on page 17 ).
3. Remove the access panel (on page 18 ).
4. Remove the expansion slot cover (" Removing the expansion slot cover " on page 38 ).
5. Install the SAS controller (" Installing expansion boards " on page 39 ).
6. Disconnect the SATA cable from the hard drive backplane and the system board.
7. Connect the SAS cable to the hard drive backplane and to the SAS controller (" SAS hard drive cabling "
on page 49 ).
8. Install the access panel (on page 18 ).
9. Lock the bezel.
10. Power up the server (on page 16 ).
Parallel and second serial connector
To install the component: