HP ProLiant ML310 G5p Server - Manual (Page 29)

Hardware options installation 29
Slot 1A Slot 2B Slot 3A Slot 4B Total memory Mode
2 GB — 2 GB — 4 GB Single-bank interleaved
2 GB 2 GB 2 GB — 6 GB Dual-bank asymmetric
2 GB 2 GB 2 GB 2 GB 8 GB Dual-bank interleaved
Installing DIMMs
1. Power down the server (on page 16 ).
2. Unlock the bezel (on page 17 ).
3. Remove the access panel (on page 18 ).
4. Open the DIMM slot latches.
5. Install the DIMM.
6. Install the access panel (on page 18 ).
7. Lock the bezel.
8. Power up the server (on page 16 ).
Hard drives
The server supports non-hot-plug SATA hard drives.
Optional hot-plug SATA or SAS hard drives may be supported in select configurations ("
SAS controller " on
page 41 ).
The SATA RAID feature supports the following configurations:
• Two RAID volumes with two hard drives per volume
• One RAID volume with four hard drives
Hot-plug SATA and hot-plug SAS hard drives can be used interchangeably when a SAS controller is installed.
Before installing a SAS hard drive, you must install a SAS controller (" SAS controller " on page 41 ). A SATA
controller is embedded for use with SATA drives only.