HP Insight Control - Manual (Page 14)

Default setting Component
All NICs are enabled. SNMP is enabled. The default value of the SNMP community is public. Networking
Virtualization Host features
These features enable you to deploy Hyper-V or ESX via a scripted install.
•
The design of the Hyper-V features is very similar to Windows.
•
The design of the ESX features is very similar to Linux.
•
Imaging of virtualization hosts is not supported.
•
The scripted install jobs include a system configuration task to enable processor virtualization extensions.
Table 3-7 Hyper-V scripted install default settings
Default setting Component
The administrator password is password. Administrator password
A single partition is created automatically that expands to the full drive size. Drive configuration
The computer name uses the 15 right-most characters of the console display name. Computer name
Firewall settings are disabled. Firewall
Added to workgroup "WORKGROUP". SNMP and WMI are enabled. Networking
Table 3-8 ESX scripted install default setting
Default setting Component
The root password is password. This password is stored in encrypted form in the kickstart file. HP
recommends changing the default root password. Root password
When configuring the disk partition for a scripted operating system installation, various VMware
ESX Server specific partitions are created. These settings are default. Do not change them. Drive configuration
The host name uses the console display name. Host name
VMware ESX Server specific packages are installed. Do not change this setting. Packages
Firewall settings are disabled. SSH configuration modified to allow root login. Firewall
14 Reference