Install the software for a network connection – HP Photosmart Plus e-All-in-One Printer - B210e User Manual

Page 41

e. In the Network key box, type a WEP key that has exactly 5 or exactly 13

alphanumeric (ASCII) characters. For example, if you enter 5 characters, you
might enter ABCDE or 12345. Or, if you enter 13 characters, you might enter
ABCDEF1234567. (12345 and ABCDE are examples only. Select a combination
of your choosing.)
Alternatively, you can use HEX (hexadecimal) characters for the WEP key. A HEX
WEP key must be 10 characters for 40 bit encryption, or 26 characters for 128 bit
encryption.

f. In the Confirm network key box, type the same WEP key you typed in the

previous step.

NOTE:

You must remember the exact uppercase (capital) and lowercase

(small) letters. If you enter your WEP key incorrectly on the product, the
wireless connection will fail.

g. Write down the WEP key exactly as you typed it, including uppercase and

lowercase letters.

h. Select the check box for This is a computer-to-computer (ad hoc) network;

wireless access points are not used.

i. Click OK to close the Wireless network properties window, and then click OK

again.

j. Click OK again to close the Wireless Network Properties Connection window.

Install the software for a network connection

Use this section to install the HP Photosmart software on a computer connected to a
network. Before you install the software, make sure you have connected the
HP Photosmart to a network. If the HP Photosmart has not been connected to a network,
follow the onscreen instructions during the software installation to connect the product to
the network.

To install the Windows HP Photosmart Software on a networked computer

Quit all applications running on your computer.

Insert the Windows CD that came with the product into the CD-ROM drive on your
computer and follow the onscreen instructions.

NOTE:

If you will use the HP Photosmart over a wireless network connection

and it is not connected to a network, you will be prompted to run the Wireless
Setup Wizard from the product’s front panel before continuing the software
installation. If you don’t know your wireless settings the software can help find
them for you.

NOTE:

Some products require a temporary USB cable connection to make a

wireless network connection. The software will prompt you when to make this
temporary connection if it is required.

Add the HP Photosmart to a network

Connectivity