HP Integrity NonStop J-Series - Manual (Page 21)

Pocket ViewPoint User Guide H02 – 545765-002
- 21 -
 During the obeying of files, a STRTPVP error may be generated. This occurs due to the
command to stop the processes may not result in the process(es) being stopped. The
recovery is to “Skip Command”.
 After a new install user might encounter an error ems message “CSVR:Could not open
file WDSM001 Error 11”. CPROCAPP creates the WDSM001 file which CSVRAPP
attempts to open. If due to timing issues, CSVRAPP tries to open this file before
CPROCAPP has had a chance to create it, then this error message would occur. If this
occurs after a fresh install, then it can be ignored.
[Back to TOC]
2-2-3 Manual Install (NonStop)
In situations where the Wizard Install is not possible users also have an option to perform the
installation manually.
2-2-3-1 Overview
For performing manual installation, the user will need to FTP files manually and follow the
installation procedure described below. Note that this is not our recommended process of
installation.
2-2-3-2 Process
For the Manual Installation, use the WS_SW\Manual Install\ascii and \binary folders from the
CD as specified below:
a. The following files need to be transferred in ‘ ASCII ’ mode to $volume.subvolume
COLLCONF
INSTPVP
PVPBAMIM
PVPCONF
STOPPVP
STRTPVP
b. The following files need to be transferred in ‘BINARY‘ mode to $volume.subvolume
CPROCAPP
CSVRAPP
FINFLIB
FINFO
FDIST
LISTAPP
POCKETVP
PROCMAN
PSVRAPP
PVPEVTS
PVPTMPAK