HP Integrity NonStop H-Series - Manual (Page 9)

ViewSys User’s Guide— 526358-002
vii
About This Manual
ViewSys gives system managers and system operators the ability to view system
resources on HP NonStop systems. It also provides data to those responsible for load
balancing and overall system performance.
ViewSys returns system resource information interactively, reporting data similar to that
provided by PEEK, another HP NonStop resource reporting utility, and Measure, an HP
NonStop performance analysis tool. PEEK displays resource use from a specific
timestamp to the present. ViewSys provides the average resource use for each polling
period.
Measure provides detailed resource use for each interval, but the results are generally
interpreted offline after the measurement is complete. ViewSys allows the viewing of
system resources in an online environment, so you can view the effects of process
relocations or the altering of controller paths as the changes are made. ViewSys must
be run from an HP block mode terminal or from any HP NonStop terminal emulator.
If you are familiar with either Measure or PEEK, you can translate that knowledge to
this utility and need only become familiar with the commands and function keys to
control the utility. If you are unfamiliar with the resources being measured, first read the
Measure User's Guide.
Manual Organization
The manual is organized as follows:
•
Section 1, Getting Started , describes the program execution and the basic
operational function key commands.
•
Section 2, ViewSys Overview , discusses the display modes in more detail. It
contains general information as an introduction to the next section.
•
Section 3, ViewSys Run Command Syntax , covers the various run commands that
define and control the utility.
•
Section 4, Function Key Commands , defines each function key that can be used to
control the utility.
•
Section 5, Interpreting ViewSys , discusses the resources measured and the
interpretation of the values displayed.
•
Section 6, Measurement Techniques , describes the internal measurement
techniques used in the utility.
•
Appendix A, ViewSys Syntax Summary , lists the command syntax and keywords.
•
Appendix B, ViewSys Measurement Entities , shows the formulas used to derive
the bar graph percentages as displayed.
•
Appendix C, ViewSys Help Screen , explains the help screen.