HP Integrity NonStop H-Series - Manual (Page 28)

ViewSys Run Command Syntax
ViewSys User’s Guide— 526358-002
3 -6
HELP Command
Example
VIEWSYS FUNCTIONKEYS OFF
HELP Command
Use the HELP command to display a list of the run-time commands. After the
commands appear, ViewSys exits and automatically returns you to the TACL prompt.
Example
VIEWSYS HELP
MULTITYPE Command
Use the MULTITYPE command to indicate the number of entities displayed on each
screen.
ON
indicates that when monitoring eight or fewer processors, two individual entities
appear concurrently. If you are monitoring more than eight processors, this
command is ignored. This value is the default.
OFF
indicates that only one entity appears on each screen.
Example
VIEWSYS MULTITYPE OFF
NUMCPUS Command
Use the NUMCPUS command to indicate which processors are being monitored.
Processors numbered 0 through (number - 1) will be monitored. Subsequent
USERCPUS commands cause additional processors to be monitored if the processors
specified therein were not within the range specified by the NUMCPUS command.
HELP
MULTITYPE { ON | OFF }
NUMCPUS number