HP Integrity NonStop H-Series - Manual (Page 27)

ViewSys Run Command Syntax
ViewSys User’s Guide— 526358-002
3 -5
EXITAFTER Command
EXITAFTER Command
Use the EXITAFTER command to specify the number of samples to be displayed
before ViewSys terminates and returns you to the TACL prompt. If you omit this
command, ViewSys runs continuously until you use a function key to exit.
number
must be in the range 1 through 32767.
Example
VIEWSYS EXITAFTER 100
EXITKEY Command
Use the EXITKEY command to specify a function key to exit the program in addition to
the default EXIT key. If you omit this command, the program operates continuously
until you strike the predefined EXIT function key (F16 or Alt-F6).
integer
must be an integer in the range 1 through 16.
FUNCTIONKEYS Command
Use the FUNCTIONKEYS command to specify whether the ViewSys function keys
should be operational.
ON
indicates that the function keys with which you control ViewSys are operational.
This value is the default.
OFF
indicates that the function keys are disabled. When running ViewSys in this mode,
you must determine the display type at startup time and issue the proper DISPLAY
command. When you run ViewSys in this mode, you must stop it from another
terminal.
EXITAFTER number
EXITKEY integer
FUNCTIONKEYS { ON | OFF }