Pegasus service in the services window – HP 2000SA G2-Modular-Smart-Array User Manual
Page 12
5.
Select Typical Installation and click OK to install Pegasus, the Proxy Providers, and PSM
automatically. The installation status is displayed on the user interface. Installation typically takes
6–8 minutes.
NOTE:
If a Pegasus CIMOM is already installed on the server and is version 2.7.0 or above, the
installer will skip the CIMOM installation and integrate the provider set into the existing
CIMOM installation.
If a Pegasus CIMOM is already installed on the server and is a version lower than 2.7.0,
the installer will install CIMOM version 2.7.1, but would ensure that the existing CIMOM
binaries and all the relevant folders are undisturbed. However, if the existing installation
has Pegasus installed as a Windows service, the current installation will overwrite it. After
the installation, the Pegasus service entry will refer to the CIMOM from this package, and
the existing Pegasus CIMOM can only be run as a process and not as a Windows service.
If the existing CIMOM is already using the default port 5989, the new CIMOM would choose
a different port as described in
Ports and the service utility (Windows only)
The x86 version of the provider set will not work with an x64 version of the CIMOM and
hence while installing on an x64 server, if an x64 version of Pegasus CIMOM already exists,
the installation would fail.
NOTE:
To select components or specify a different installation directory, select Custom Install and
follow the instructions on the screen. Only the selected components will be installed.
6.
After the installation script completes, you can validate the installation by verifying that the Pegasus
service is started in the Services window as shown in
Figure 3 Pegasus service in the Services window
.
Installing and uninstalling the SMI-S Proxy Provider
12