HP Integrity NonStop J-Series - Manual (Page 82)

SDR Commands
HP NonStop SQL DDL Replicator User’s Guide —545799-007
6-18
START UPDATE
Note that an EMS collector is not a valid Guardian home terminal. If the
HOMETERM option is specified as an EMS collector, the home terminal of the
Guardian monitor process (or $ZHOME for S-Series systems) is used to start
the SDR monitor process. Subsequently, all messages are sent to the EMS
collector.
PRIMARY cpu-number
a cpu-number (in the range of 0 to 15) of the primary monitor processes.
PRIORITY process-priority
the priority (in the range of 1 to 199) for the monitor process.
UPDATE { HOLD | OFF }
instructs the monitor to start the SDR updaters in a hold state, or not start the
SDR updaters.
HOLD
the updaters are started in the HOLD state. A subsequent RELEASE
command will allow the SDR updaters to replicate SQL DDL.
OFF
the SDR updaters are not started. A subsequent START UPDATE
command is required to start the SDR updaters.
The UPDATE option applies only to SDR updaters for current RDF
configurations. New RDF configurations may have an SDR updater started for
them. For a permanent control of SDR updaters, set the RDFCONFIG global
parameter as appropriate.
START UPDATE
Starts the SDR updater that manages the specified RDF configuration (or all SDR
updaters).
SDR updaters that are already executing are not affected by this command.
RDF-control-subvol
an RDF configuration in the format node[suffix-character] that replicate the SQL
objects that are the target of DDL operations managed by the SDR updater.
If RDF-control-subvol is omitted, all SDR updaters are started.
HOLD
instructs the monitor to start the SDR updater in the HOLD state.
START UPDATE [ RDF-control-subvol ] [, HOLD ]