HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem User Manual
Page 28
Component identification 28
HP Virtual Connect 4Gb FC Module system maintenance switch
Switch Default Function
1 Off
Reserved
2 Off
Reserved
3 Off
Reserved
4 Off
Reserved
When part of a Virtual Connect domain, Virtual Connect Manager overrides any system maintenance
switch settings.
Resetting the Administrator password and DNS
settings
If the system maintenance switch 1 is in the ON position on a VC-Enet module, the firmware restores the
Administrator account password and DNS settings to the original factory defaults as found on the module
label (without disturbing any other local user accounts), and also displays the password on the VC-Enet
module management console. For information on accessing the VC-Enet module management console,
see the OA user guide. The default password is no longer displayed after switch 1 is in the OFF position.
Password restoration is done during each power-up sequence while switch 1 is in the ON position (and
reserved switches are in the OFF position) and does not allow changes until the switch is placed back into
the OFF position. For switch locations, see the appropriate system maintenance switch ("
Enet Module system maintenance switch
HP 1/10Gb-F VC-Enet Module system
" on page
HP Virtual Connect Flex-10 10Gb Ethernet Module system
After switch 1 is returned to the OFF position, users with appropriate privileges can then change the
Administrator password.
Only reset the password on the module running the Virtual Connect Manager (and/or its backup), and
not other modules in the domain.