HP Scanjet N7710 Document Sheet-feed Scanner - Manual (Page 6)

Scanner hardware
1 Front panel. For information, see Scan from the scanner buttons .
2 Document feeder. For information, see Use the document feeder .
3 Card slot. For information, see Load cards .
4 The Power rocker switch is located on the back of the scanner.
Scanner lamp setting
The scanner supports two modes of lamp operation:
•
In Power Save mode, the scanner lamp times out and turns off automatically after
about 15 minutes of inactivity. In this mode, the scanner is Energy Star compliant.
• In Instant Lamp On mode, the scanner lamp times out and turns off automatically
after about 15 minutes of inactivity, but it remains warm and ready to scan.
To switch from Power Save mode to Instant Lamp On mode, select the Enable Instant
Lamp On check box on the Buttons tab of the HP Scanner Tools Utility. To switch back
to Power Save mode, clear the Enable Instant Lamp On check box.
Scanner software
The scanner comes with an assortment of scanning and document-management
programs, including:
• HP Smart Document Scan Software
• HP Scanner Tools Utility
For more information and detailed descriptions of the software from other manufacturers
that is included with the scanner, see the printed Setup and Support Guide that came
with the scanner.
Chapter 1
4 Scanner overview