HP Scanjet N7710 Document Sheet-feed Scanner User Manual
Page 29
The feed roller replacement kit contains a feed roller mechanism, a separation pad, and
installation instructions. To order the replacement kit, go to
To replace the feed roller and separation pad, follow these steps:
1. Press the Power switch to the off position, and then disconnect the USB cable and
power supply from the scanner.
2. Replace the feed roller and separation pad as described in the installation instructions
that were included with the replacement kit.
3. Close the scanner hatch, and then reconnect the USB cable and power supply to the
scanner.
4. Update the scanner maintenance history:
a. Press the Tools ( ) button on the scanner front panel to open on the HP Scanner
Tools Utility.
b. In the Feed Roller and Separation Pad Maintenance section of the
Maintenance tab, click Record Replacement.
For more information, see the HP Scanner Tools Utility help.
NOTE: HP recommends that you replace the feed roller and the associated
separation pad every 100,000 scans.
The HP Scanner Tools Utility can remind you when service is needed, which depends
on many conditions and might be sooner than this replacement interval.
Replace the feed roller and separation pad
27