HP ProLiant BL20p G3 Server Blade - Manual (Page 98)

Server Blade Troubleshooting
System Maintenance Switch Procedures
When you perform troubleshooting steps, this guide may instruct you to perform the
following procedures:
•
Clear the system configuration.
•
Access the redundant ROM.
IMPORTANT: Do not perform these procedures until directed to do so by the troubleshooting
tables in this appendix.
To complete these procedures, you must change physical settings on the system
maintenance switch (SW2). For switch locations and positions, refer to Chapter 1,
“Server Blade Component Identification.”
Clearing the System Configuration
To clear the system configuration:
1. Power down the server blade using one of the following procedures:
— Press the Power On/Standby button on the front of the server blade.
— Use the virtual power button feature in the iLO remote console.
2. Disconnect the server blade from all power sources using one of the following
procedures:
— Remove the server blade from the server blade enclosure and set it on a flat,
level surface.
— Disconnect the server blade from the diagnostic station.
3. Remove the access panel. Refer to the “Accessing Internal Server Blade
Components” section in Chapter 3, “Server Blade Setup.”
4. Change position 6 of SW2 to on.
5. Install the access panel. Refer to the “Accessing Internal Server Blade
Components” section in Chapter 3, “Server Blade Setup.”
HP ProLiant BL20p Generation 3 Server Blade User Guide A-13