HP ProLiant BL20p G3 Server Blade - Manual (Page 26)

Server Blade Setup
4. Place the server blade on a flat, level surface.
5. Remove the access panel. Refer to “Removing the Server Blade Access Panel” in
this chapter.
Removing the Server Blade Access Panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Electrostatic discharge can damage electronic components. Properly
ground yourself before beginning any installation procedure. Refer to Appendix D,
“Electrostatic Discharge,” for more information.
WARNING: To reduce the risk of electric shock, do not power up the server
blade with the access panel removed.
1. Loosen the thumbscrew on the rear of the server blade (1).
2. Slide the access panel about 1 cm (3/8 in) toward the rear of the unit and lift the
panel to remove it (2).
Figure 3-1: Removing the access panel
3-2 HP ProLiant BL20p Generation 3 Server Blade User Guide