HP StoreEver Rack-mount Kits - Manual (Page 6)

Figure 3 Enclosure internal SAS cable
4. SAS connector routes device to external port 1 1. and 3. Power connectors (used only with LTO-5, LTO-6,
and DAT; do not use with other LTO drives)
5. SAS connector to PC board within the enclosure 2. SAS connector routes device to external port 2
NOTE: Power for all DDS, LTO-5, and LTO–6 tape drives is supplied through the SAS cable. For
all earlier models of LTO tape drive, plug the power cable directly into the drive.
Hardware Options
For a list of currently supported hardware options, such as tape and DVD drives and media, visit
the HP website at:
http://www.hp.com/go/tape .
Cable Management System
The 3U Rack-mount Enclosure ships with a cable management system. This system was designed
to better assist you when maintenance is needed.
NOTE: The cable management system is only for use in 10000, 11000, and Intelligent Series
racks.
The following figure shows how the cable management system channels the system cables along
the back of the storage enclosure and to the connection points on the rack.
Figure 4 Cables routed at the rear of the enclosure
6 Introduction