HP Integrity NonStop J-Series - Manual (Page 36)

Configuring the Tape Drive for the NonStop
BladeSystem Server
5344-2SE Tape Drive Installation and User’s Guide — 546010-001
B- 2
Start the Tape Drive
Start the Tape Drive
After the tape drive is added, use the START command to start it:
-> START TAPE $5344
Verify the Tape Configuration
To check that the tape drive was successfully added, issue the SCF STATUS tape-
name, detail command:
-> STATUS TAPE $5344, DETAIL
STORAGE - DETAILED STATUS TAPE \OSMQA5.$5344
Tape Process Information:
Tape I/O Process Information:
Library File.......
Program File....... $SYSTEM.SYS00.OTPPROCP
Current Settings:
LDev State Primary PID Backup PID DeviceStatus
197 STARTED 0,322 1,351 ONLINE, BOT
ACL................ NOT INSTALLED Buffer Level...... RECORD
Checksum Mode...... NORMAL I/O *Compression....... ON
*Density............ 38000 Media Type........ Not applicable
Opens.............. 0 *RecSize........... 2048
Short Write Mode... ALLOWED, PADDED SubType........... 16
Volume Switching... TRANSPARENT