Connecting to networks, Connecting to wireless networks – HP Slate 21-s100 All-in-One User Manual

Page 20

Connecting to networks

You can connect to networks with either a wired (Ethernet) or wireless (Wi-Fi) connection. You cannot
enable Ethernet and Wi-Fi connections at the same time.

Connecting to wireless networks

The all-in-one’s wireless network capability lets you connect the all-in-one to wireless local area
networks (commonly referred to as Wi-Fi networks, wireless LANs, or WLANs). In a WLAN, the
mobile wireless module in your all-in-one communicates with a wireless router or a wireless access
point.

NOTE:

To set up a WLAN and connect to the Internet, you need a broadband modem (either DSL

or cable) (purchased separately), high-speed Internet service purchased from an Internet service
provider, and a wireless router (purchased separately).

To connect to a wireless network:

Select the All Apps icon from the Home page, and then select Settings.

Select Wi-Fi.

Select the ON button to turn the wireless radio on.

Select your WLAN from the list.

NOTE:

If no WLANs are listed, you may be out of range of a wireless router or access point.

If the WLAN is security-enabled, you are prompted to enter a security code. Type the code, and
then select Connect.

Chapter 2 Setting up the hardware