beautypg.com

Setting up the hardware, Preparing for desk use, Preparing for wall mounting – HP Slate 21-s100 All-in-One User Manual

Page 10: 2 setting up the hardware, Preparing for desk use preparing for wall mounting, 2setting up the hardware

background image

2

Setting up the hardware

You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or
swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the
cables after you have installed the all-in-one to a mounting fixture.

To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached
accessories, and then follow the instructions below for your configuration.

Preparing for desk use

To assemble the all-in-one for desktop use:

1.

Set the all-in-one face down on a flat, soft, protected table or desk surface.

2.

Pull the stand outward until you hear it click.

3.

Lift the all-in-one to an upright position and place on a flat, stable surface.

Preparing for wall mounting

NOTE:

This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket.

You can only VESA mount the all-in-one in landscape orientation with the rear ports facing down. Do
not place in portrait orientation.

To attach the all-in-one to a mounting fixture:

1.

Set the all-in-one face down on a flat, soft, protected table or desk surface.

4

Chapter 2 Setting up the hardware